Banner
Color Paste - Silver Grey | Print |  E-mail

MATERIAL SAFETY DATA SHEET

Trade Name: SILVER GREY COLOUR PIGMENT

Chemical Family: Unsaturated Polyester Resin
Formula: N/A

Manufacturer: VENGAR COLOURS & COATINGS INC.
#E-12355 – 83A Avenue
Surrey, BC V3W 9Y7
Emergency Phone #’s: (604) 501-4872

Supplier:
Industrial Plastics & Paints
776 Cloverdale Ave
Victoria, BC V8X 1S7
(250) 727-3545

Transportation EMG. Phone # CANUTEC (613) 996-6666 or (604) 930-0650

HAZARDOUS INGREDIENTS:
Silica Amorphous (SIO2): >=5-<10% CAS # 7631-86-9
Carbon Black: >=0.1-<0.5% CAS # 1333-86-4
Aluminum Oxide (AL2O3): >=1.5-<5% CAS # 1344-28-1
Titanium Dioxide (TIO2): >=50-<60% CAS # 13463-67-7
Zirconium Oxide >=1-<1.5% CAS # 1314-23-4

Exposure Limits:
Silica Amorphous (SIO2): LD50 oral rat: 10,000mg/kg, LD50 dermal rabbit 5,000 mg/kg, LC50 inhl. Rat: 0.139 mg/l
Carbon Black: LD50 oral rat: 15,400mg/kg, LD50 dermal rabbit 3 mg/kg
Titanium Dioxide (TIO2): LD50 oral rat: 24,000mg/kg, LD50 dermal rabbit 10,000 mg/kg, LC50 inhl. Rat: 6,850 mg/l

PHYSICAL DATA:
Appearance & Odour: Light grey paste no odour.
Vapour Pressure: N/A
Vapour Density: (Air = 1) >1
Solubility in Water: Nil
Specific Gravity: N/A
Evaporation Rate: Slower than ether
Boiling Point: N/A
Freezing Point: N/A
pH: N/A

FIRE & EXPLOSION DATA:
Flashpoint & Method: >93.3°C (SCC)
Flammable Limits: N/A
Extinguishing Methods: Foam, Carbon Dioxide, Dry chemical, Water fog
Special Equipment & Procedures: Self contained breathing apparatus. Sensitive to static discharge.

REACTIVITY DATA:
Conditions Contributing to Instability: Heat, open flame, and prolonged storage at elevated temperatures.
Incompatible Substances: Lithium, strong acids, strong bases, strong oxidizing agents
Hazardous Decomposition Products: May form carbon dioxide and carbon monoxide, toxic fumes, various hydrocarbons.
Hazardous Polymerization: Will not occur.

HEALTH HAZARDS DATA:
NOTE: Health studies have shown that exposure to chemicals pose potential risks which may vary from person to person. Exposure to liquids, vapours, mists or fumes should be minimized.

PRINCIPAL HEALTH HAZARDS:
Skin Contact: May cause irritation including redness, burning, drying and cracking of skin, burns and other skin damage.
Eye Contact: Can cause eye irritation including stinging. tearing, redness and swelling of eyes.
Ingestion: Swallowing large amounts may be harmful.
Inhalation: Breathing of capour or mist is possible. Breathing large amounts may be harmful. Symptoms usually occur at air concentrations higher than the recommended exposure limits

FIRST AID PROCEDURES:
Skin: Wash with soap and water. Remove contaminated clothing and launder before reuse.
Eyes: Flush gently with water while holding eyelids apart. If irritation persists seek medical attention.
Ingestion: Seek medical attention. If individual is drowsy or unconscious, do not give anything by mouth; place individual on their left side with head down. Contact a physician, medical facility or poison
control center for advice on whether to induce vomiting.
Inhalation: Remove to fresh air.

PREVENTIVE MEASURES:
Skin: Always apply appropriate barrier cream to exposed skin. Wear impervious gloves (butyl rubber), coveralls and safety footwear.
Eyes: Chemical proof goggles or full face respirator if vapours cause eye irritation.
Ingestion: Wash thoroughly before consuming food stuffs.
Inhalation: Use only in well ventilated areas or use NIOSH approved respiratory protection with organic vapour cartridges.

CONTROL MEASURES & PRECAUTIONS
Keep container tightly closed. Do not consume food, drink or tobacco in work area or material storage areas. Use caution and personal cleanliness to avoid skin and eye contact. Avoid breathing vapours of heated materials. Use paper covering absorbent wipes and suitable disposable containers in work area.

SPILL, LEAK & DISPOSAL METHODS
Review fire and explosion hazards and safety precautions before proceeding with clean up. Restrict access to area. Contain spill to prevent liquid from entering sewers or waterways. Recover free liquid and use an absorbent material (i.e. sand, vermiculite) to soak up balance. Place in suitable container for disposal.

DISPOSAL METHOD
Dispose only in a facility permitted to dispose of hazardous waste by Federal, Provincial and Municipal regulations.

SHIPPING INFORMATION
Shipping Name:
Hazard Class: None Regulated
UN/PIN #:
Flashpoint:
WHMIS:

The information contained herein is based on data that we believe to be accurate. No warranty either expressed or
implied is made. This information is offered solely for your consideration interpretation and information.

Preparation Date: September 1, 2000
Prepared by: Ron Sherring, 776 Cloverdale Ave, Victoria BC V8X 1S7
Telephone #: (250) 727-3545
Revised Date:
July 1, 2011

 
Banner
Footer Locate an IPP Store near you Follow IPPTWEET on Twitter Click to sign up for our WebMail Click to see whats new at IPP Click to go to our latest Flyer Click to open our Facebook page