Home > Products > PLASTICS > Sheet Substraits > FRP Sheet
Sheet Substraits
FRP Sheet
Glasbord FRP
(Fibreglass Reinforced Panels) is the only FRP panel to feature Surfaseal,a sealed protective finish. Glasbord with Surfaseal is resistant to scratches, abrasions, staining and damage due to harsh chemicals.Glasbord is available in different colours and finishes and can be easilly cut and drilled for easy installation. Glasbord is perfect for a wide variety of applications where ease of cleaning, sanitation or abuse resistance is required.
Glasbord is ideal for use in for foodprocessing plants, refrigerated warehouses, locker rooms, public bathrooms, daycare centres, breweries and laboratory installations.
Glasbord is easy to install, tough and easy to clean wall and ceiling panel.Ask your local store for details for your project. Accessories such as colour coordinated moldings are also available to complete your installation.
tand up to harsh conditions while maintaining a sanitary surface that looks likes new!
|
Features and Benefits:
|
Applications:
|
Clean frp wall or ceiling panels on a regular basis so that soil and dirt will not build up. A mild non-abrasive cleaner is recommended.
A 5% to 10% trisodium phosphate water solution not to exceed 130°F (55°C), can be used. If trisodium phosphate is not available, use a 5% to 10% solution of household automatic dishwasher detergent. If a USDA or FDA approved cleaner is required, a neutral cleaner (pH range 6.5 - 7.5) is preferred. Follow the manufacturer's directions. Do not use a cleaner or stain remover that contains chlorinated hydrocarbons or aromatic hydrocarbons. Do not use abrasive cleaners.
FRP can best be cleaned with a sponge or soft brush. Wire brushes or other abrasive tools or pads will scratch the surface. Apply the cleaner, working it across the surface in a scrubbing or circular motion. Rinse thoroughly to remove all traces of the cleaner, otherwise a film will build up giving the panel a dull, dirty appearance. When using a specialty cleaner, follow the manufacturer's instructions. Test a small area before applying over the entire surface.
To clean hard water deposits use a 10% solution of acetic acid in COLD water. Use the same cleaning procedures outlined above. If the panel surface becomes dull or abraded, complete cleaning may not be possible.
 |
| INSTALLATION INSTRUCTIONS |